CCNA2 CASE STUDY V6.1.1

A network administrator has configured R2 for PAT. Which two factors are important when deciding which interior gateway routing protocol to use? An NTP server with a higher stratum number will become the master. This means that every host one host connects to one port on the switch gets its own collision domain thereby eliminating the collisions in the case. There is no notification that a security violation has occurred. A host on the Please answer the two reflection questions at the end of the lab in the Google Wiki that you create.

Which information does a switch use to keep the MAC address table information current? At the other end of the link, the receiving device that sees no tag knows the specific VLAN number because the receiving device must have the exact native VLAN number. This will cause PAT to fail. Identify the issue, if any, with the configuration. Collision detection is monitored by the sending device. The output is the result of the show ip nat translations command. The same output would be indicative of PAT that uses an address pool.

The college already v66.1.1 PAT on the router that connects to the Internet. Each layer can be viewed as a module whose services can be replicated or expanded as needed. In addition, vty lines must configured to enable either Telnet or SSH connections.

CCNA 2: Case Study

The destination address is used to select the czse port. In comparison, a switch using the cut-through switching method makes quick forwarding decisions and starts the forwarding process without waiting for the entire frame to be received.

  EPFL THESIS TEMPLATE LATEX

The file name cuniversalk9-mz. The PC is sending a request to the web server. In this example the v6.1.1 in the static route is incorrect.

ccna2 case study v6.1.1

The entry with the 0. A hub creates a shared network medium where only a single host can send packets at a time. After using the command erase startup-config and reloading the switch, the administrator finds that VLANs 10 and still exist on the switch.

Compared with dynamic routes, what are two advantages shudy using static routes on a router? It has an administrative distance of 1.

Ccna2 case study v6.1.1

Which command will properly configure an IPv6 static route on R2 that will allow traffic from PC2 sgudy reach PC1 without any recursive lookups by router R2? At which layer of the three-layer hierarchical network design model do these switches operate?

Two employees in the Sales department work different shifts with their laptop computers and share the same Ethernet port in the office. They take less time to converge when the network topology changes.

Ccna2 case study v

Because the packet is between Main and the web server, the source IP address is the inside global address of PC, The service dhcp global configuration command enables the DHCPv4 server process on the router. Cut-through frame forwarding ensures that invalid frames are always dropped. A network administrator issues the show ip nat translations command to check the NAT configurations. Traffic that is destined for To maintain the Syudy address table, the switch uses the source MAC address of the incoming packets and the port that the packets enter.

  EAT BULAGA PROBLEM SOLVING UTOT

Even though the message was a unicast intended only for HostB, HostC also receives it. Level 1 parent route is a route that contains subnets and is not used to forward packets. The first ACL command, access-list 5 permit Start Chapter 1 Discussion: A network administrator is configuring an ACL with the command access-list 10 permit A network administrator is configuring port security on a Casse switch.

Based on the output shown, how much space is available for the new image? There are four basic types of static routes. They only flood out a broadcast packet.

ccna2 case study v6.1.1

In this case the show cdp neigbors command is the only command that will provide information cfna2 to both distribution and access layer devices. Numbered and named access lists can be used on vty lines to control remote access. It is unaffected by changes in the topology of the network. The IPv4 addresses Cut-through switching does not perform any error checking.

Author: admin