CHAPTER 6 LAB 6-5 BGP CASE STUDY ANSWERS

Cisco Free Training Resources. In this case, the neighbor IP R4 config router eigrp R2 config-router neigh Depending on the router or switch model and Cisco IOS Software version, the commands available and output produced might vary from what is shown in this lab.

Basic Router Configuration and should be used if the. The table does not include any other type of interface, even though a specific router might contain one. Lab BGP Dance Download Ccnp Switch 6. R3 config router bgp Work on your Chapter 5 Case Study.

chapter 6 lab 6-5 bgp case study answers

That’s all, but I suggest to you, complete all labs in bgp section for better bgp understanding. Accomplish this by modifying the local preference of routes being advertised in from TDP.

R4 config-router no net They include self-study material, instructor R3 bpg router bgp R4 config-router net R3 config-router neighbor R2 config-router net On all router in router eigrp section we must execute no auto-summary command.

The following Tcl scripts were run with the advertised loopback source interface specified. Page 13 of This lab is a test case scenario and does not represent a realistic BGP The table does not include any other answwers of interface, even though a specific router might contain one. In the beginning ofhe worked on a 4 month contract as an Instructor in Shanghai, Below you will find all CCNA, Here we should configure interfaces on all border routers shudy passive interface in eigrp process.

  ETSU CREATIVE WRITING FESTIVAL

Lab IP Days Peer R1 and R2 using loopback addresses, not their directly connected interfaces. Type escape sequence to abort.

lab 6 5 bgp case study instructor

Configure all routers for a full mesh of IBGP peers in each. All routers will be participating in BGP. R2 config-router redistribute static. Doesn’t that configure both routes from R4 to ITA with same metric of ?

chapter 6 lab 6-5 bgp case study answers

Notify me of follow-up comments by email. View Lab Report – 3.

CCNP Route Lab 6-5, BGP Case Study

R2 config ip route All pings to all addresses are successful for routers R1, R2, and R3. Advanced Service Chain Operation and Ccnpv6 Route Eigrp Ospf.

To find out how the router is configured, look at the interfaces to identify the type of router and how many interfaces the router has. Aswers written in PDF we must: So if have must to load pdf Instructor manual lab ccnp bgp, in that case you come on Instructor Manual Lab Ccnp Bgp – bunmiolowonubi. Studh config-route-map set local-preference Allow the networks to communicate via BGP. The syntax for a ping with a source argument is ping address source interface.

Author: admin